We write, we don’t plagiarise! Every answer is different no matter how many orders we get for the same assignment. Your answer will be 100% plagiarism-free, custom written, unique and different from every other student.
I agree to receive phone calls from you at night in case of emergency
Please share your assignment brief and supporting material (if any) via email here at: [email protected] after completing this order process.
Packet Tracer - Configure a Wireless Network
In this activity, you will configure a wireless router and an access point to accept wireless clients and route IP packets. Furthermore, you will also update some of the default settings.
WR will act as a switch to the devices connected to the LAN and as a router to the internet. Admin is now connected to the LAN (GigabitEthernet 1). WhenPacket Tracer displays green triangles on both sides of the connection between Adminand WR, continue to the next step.
Note: If no green triangles are shown, make sure to enable Show Link Lights under Options > Preferences. You may also click Fast Forward Time just above the Connections selection box in the yellow bar.
To reach theWR management page, Adminmust communicate on the network. A wireless router usually includes a DHCP server, and the DHCP server is usually enabled by default on the LAN. Adminwill receive IP address information from the DHCP server on WR.
What is the IP address of the computer?
Type your answers here.
What is the subnet mask of the computer? Show evidence of your subnet mask configuration.
What is the default gateway of the computer?Show evidence of your default gateway configuration.
Note: Values can vary within the network range due to normal DHCP operation.
Is the IP address forAdminwithin this range? Is it expected? Explain your answer.
In this step, WR is configured to route the packets from the wireless clients to internet. You will configure the Internet port on WR to connect to the internet.
Internet IP Address: 220.127.116.11
Subnet Mask: 255.255.255.252
Default Gateway: 18.104.22.168
DNS Server: 22.214.171.124
Show evidence of your configuration.
Note: If you get a Request Timeout message, close the Admin window and wait for the orange lights to turn into green triangles. Click the fast forward button to make this happen faster. Then reconnect to WR from Admin’s browser using the process explained in Step 3.
Note It may take a few seconds for the network to converge. Click Fast Forward Time or Alt+D to speed up the process.
In this activity, you will only configure the wireless settings for 2.4 GHz.
In this step, you configure the wireless security settings using WPA2 security mode with encryption and passphrase.
An access point (AP) is a device that extends the wireless local area network. An access point is connected to a wired router using an Ethernet cable to project the signal to a desired location.
In this step, you will change the internal network address from 192.168.0.0/24 to 192.168.50.0/24. When the LAN network address changes, the IP addresses on the devices in the LAN and WLAN must be renewed to receive new IP addresses before the lease is timed out.
What is the new IP address information for Admin?
Show and discuss your testing strategy adopted in this worksheet tasks.
Critically evaluate the behaviour of the system.
Get all these features for د.إ195.00 FREE
Check Out Our Original Reviews